Sp distance (speaker distance), Ged in the “crossover (crossover frequency), En-43 – Onkyo HT-r591 Manuel d'utilisation
Page 43
Advanced Operations
En-43
■
Surround Back Ch
`
1ch:
Select if only one surround back speaker is
connected.
`
2ch:
Select if two (left and right) surround back speakers
are connected.
Note
• If the “Surround Back” setting is set to “None”, this setting
cannot be selected.
■
Crossover (Crossover Frequency)
This setting is advantageous for the speakers that you
specified as “Small” in the “Sp Config (Speaker
Configuration)” (
). To get the best bass
performance from your speaker system, you need to set
the crossover frequency according to the size and
frequency response of your speakers.
`
40Hz, 50Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz,
120Hz, 150Hz, 200Hz
Use the diameter of the smallest speaker in your system
when choosing the crossover frequency.
*6
Choose the setting suitable for the speaker.
Note
• For a more accurate setting, look up the frequency response in the
manuals supplied with your speakers and set accordingly.
• Choose a higher crossover frequency if you want more sound
from your subwoofer.
■
Double Bass
`
On
`
Off
Turn this setting on to boost bass output by feeding bass
sounds from the front left, right, and center channels to the
subwoofer.
Note
• When the “Subwoofer” setting is set to “No” or the “Front”
setting to “Small”, this setting is fixed to “Off” (
).
• This setting is set to “On” automatically when the “Subwoofer”
and “Front” settings are set for the first time to “Yes” and
“Large” respectively.
Menu
Sp Distance
Here you can specify the distance from each speaker to the
listening position so that the sound from each speaker
arrives at the listener’s ears as the sound designer intended.
Note
• These settings are not available in either of the following cases:
– A pair of headphones is connected.
– The “Audio TV Out” setting is set to “On” (
).
– “HDMI Ctrl (RIHD)” is set to “On” (
) and you’re
listening through your TV speakers.
■
Unit
`
feet:
Distances can be set in feet. Range: 1ft to 30ft in
1 foot steps.
`
meters:
Distances can be set in meters. Range: 0.3m to 9.0m
in 0.3 meter steps.
(The default setting varies from country to country.)
■
Left, Front High Left, Center, Front High Right,
Right, Surround Right, Surr Back Right, Surr
Back Left, Surround Left, Subwoofer
`
Specify the distance from the each speaker to your
listening position.
Note
• Speakers that you set to “No” or “None” in the “Sp Config
) cannot be selected.
Speaker cone diameter
Crossover frequency
Over 8 in. (20 cm)
40/50/60 Hz
6-1/2 to 8 in. (16 to 20 cm)
70/80/90 Hz
5-1/4 to 6-1/2 in. (13 to 16 cm)
100 Hz
3-1/2 to 5-1/4 in. (9 to 13 cm)
120 Hz
Under 3-1/2 in. (9 cm)
150/200 Hz
This setting is NOT set automatically by
Audyssey 2EQ
®
Room Correction and Speaker Setup
).
Sp Distance (Speaker Distance)
This setting is set automatically by Audyssey 2EQ Room
Correction and Speaker Setup (
1
2
3
4
5
6