Onkyo HT-r591 - Manuel (Page 11)

En-11
Connections
Connecting the AV
Receiver
Connecting the Speaker Cables
The following illustration shows how to connect the
speakers to each pair of terminals. If you’re using only one
surround back speaker, connect it to the SURROUND
BACK or FRONT HIGH L terminals.
Tip
• You can specify whether surround back or front high speakers are
connected in the “Sp Config (Speaker Configuration)” menu
(
➔ page 42 ) or during Audyssey 2EQ ® Room Correction and
Speaker Setup ( ➔ page 27 ).
■ Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of insulation from the ends
of the speaker cables, and twist the bare wires tightly, as
shown (Supplied speaker cables are already stripped).
■ Banana Plugs (North American and Brazilian
models)
• If you are using banana plugs, tighten the speaker
terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center
hole of the speaker terminal.
Connecting Your Speakers
1/2" to 5/8" (12 to 15 mm)
Surround back/
front high
right
Surround back/
front high
left
Surround
right
Surround
left Center
Front right Front left