Remington 100582-01 - Manuel (Page 6)

6 101241
!
WARNING ICON G 001
WARNING
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Adjusting
Block
Adjusting
Screw
Sprocket
Support
Adjusting
Plate
Figure 4 - Part Locations for Assembling Guide Bar
ASSEMBLY
UNPACKING
1. Remove all items from carton.
2. Check all items for any shipping damage. If you find any
damage or if any parts are missing, promptly inform
dealer where you bought chain saw.
IMPORTANT
Do not clamp chain saw in vise during assembly.
1. Lay chain out flat.
2. Remove guide bar nuts from guide bar bolts (see Figure 3).
3. Turn adjusting screw counterclockwise (see Figure 4).
Continue to turn adjusting screw until adjusting block is to
rear of adjusting plate.
4. Install guide bar onto saw body. Place rear of guide bar
between adjusting plate and sprocket support.
IMPORTANT: Make sure to insert adjusting block into
oval adjusting hole on guide bar.
5. Attach guide bar nuts to guide bar bolts.
IMPORTANT: Tighten guide bar nuts finger tight only.
Make sure adjusting block is in oval adjusting hole on
guide bar.
6. Place chain around drive sprocket, then along top groove
of guide bar and around guide bar nose.
Note: Make sure
cutting edges of chain are facing the right direction.
Position chain so cutting edges on top of guide bar face
guide bar nose (see Figure 3).
!
WARNING ICON G 001
CAUTION
Do not place chain on saw backwards. If chain is
backwards, saw will vibrate badly and will not cut.
7. Adjust saw chain tension. Follow steps under Saw
Chain Tension Adjustment, page 7.
Drive
Sprocket
Guide Bar
Bolts
Saw
Chain
Guide
Bar
Adjusting
Hole
Guide Bar
Nuts
Cutting
Edge
Towards
Guide
Bar Nose
Sprocket
Support