Remington 100582-01 - Manuel (Page 14)

14 101241
CLEANING AND MAINTENANCE
Continued
STORAGE
If storing saw for more than 30 days, follow steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain. Clean guide bar
and chain by soaking in petroleum based solvent or mild
soap and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil. This will prevent
rust.
5. Wipe a thin coating of oil over surface of guide bar.
6. Wipe off outside of saw body. Do this with soft cloth
dampened with a mild soap and water mixture.
7. Store chain saw
• in a high or locked place, out of children’s reach
• in a dry place
• in a carrying case or with scabbard over guide bar
• with oil cap tight and saw upside down to prevent
excess oil seepage
Replacing Saw Chain
Replace chain when cutters are too worn to sharpen or when
chain breaks. Only use replacement chain noted in this manual.
Always include new drive sprocket when replacing chain. This
will maintain proper driving of chain.
Note: For proper chain
and drive sprocket, see Replacement Parts, below.
REPLACEMENT PARTS
!
WARNING ICON G 001
WARNING
Use only replacement parts described in this
manual. Use of other parts could damage saw or
injure operator.
Purchase these parts from your local dealer.
Part Number Description
097572-03S Guide bar, 400 mm (16")
091375S Chain, 400 mm (16")
097570-01 Guide bar, 355 mm (14")
091374S Chain, 355 mm (14")
075752 Drive sprocket
079417-03 Wrench/Screwdriver