RedMax BC225DL - Manuel (Page 20)

 20 
9. Maintenance
• Always be sure to stop the engine before
inspecting the brushcutter for problems or
performing maintenance.
• Never alter the brushcutter or take the engine
apart.
• When replacing parts, always be sure to use
only RedMax products or products which
have been certified by RedMax for use with
the RedMax brushcutter.
• Things to check before using brushcutter.
■ REFILLING TRIMMING LINE
1. For replacement line, use a diameter of .095
in(2.4 mm). The spool is capable for a line upto
27 ft(8 m)on the 4” head, and 46 ft(14m)on the 6”
head. Avoid using a larger line as it may cut
down the trimming performance. For safety
reasons, do not use metal line.
2. Pinch the slotted area on the both sides of the
spool housing to unhook the bottom cap. (MA1)
3. Take out the spool and pull off the old line. Put
one end of new line through the spool holes and
pull it until the length is equal between each part
of the line. (MA2)
4. Wind up the line in the correct as indicated on
the spool. (MA3)
5. Hook each end of the line in the slot on the edge
of the spool, and then put the ends through the
eyelets on the housing. Make sure that the
spring and the washers are in place. (MA4)
6. While holding the spool against the housing, pull
the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook
on the housing, press the cap against the
housing until it clicks.
WARNING
MA1
MA2
MA3
MA4