RedMax BC225DL - Manuel (Page 13)

■ MOUNTING ENGINE (SE1)
1. Loosen the bolts temporarily attached to the
clutch housing.
2. Push the driveshaft toward the gearcase and
rotate it by hand to check that the driveshaft is
engaged with the gears.
3. Insert the shaft tube into the clutch housing until
it bottoms. When difficult to engage, twist the
engine slightly.
4. Align the positioning holes on the clutch housing
and the shaft tube and fit the bolt into the holes.
And fasten the tightning bolts by turns securely.
(Tightning torque: 4.9~7.8 N.m. (0.5~0.8kg·m))
(1) Positioning hole
(2) Bolt (M5x10)
(3) Tightning bolt (M5x22)
■ INSTALLING HANDLE (SE2)
• Mount the handle to the shaft tube and clamp it
at your best operating position.
■ INSTALLING DEBRIS GUARD (SE3)
• Put the debris guard on the shaft tube near the
gear box, attach it with the 2 screws and
hardware provided.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover. (SE4)
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE5)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
6. Set up
SE1
SE2
SE3
SE4
 13 
SE5