Remington LNT-3 12-inch FR - Manuel (Page 7)

7 100583
OWNER’S MANUAL
Tapping
Screw
Front Hand
Guard
Towards
Guide
Bar Nose
Cutting
Edge
Drive
Sprocket
Guide
Bar
Bolts
Guide Bar
Nuts
Adjusting
Hole
Saw
Chain
Cutting
Edge
Guide
Bar
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Mounting
Stand-Outs
Adjusting
Block
Adjusting
Screw
Adjusting
Plate
Sprocket
Support
Figure 4 - Part Locations For Assembling Guide Bar
ASSEMBLY
Continued
FILLING OIL TANK
1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
Note: For temperatures below -1°C, use
SAE #10 oil. For temperatures above
24°C, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap
firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw is
not in use. Empty oil tank , tighten oil cap,
and store upside down after each use to
prevent seepage.