Rinse aid dispenser – Roper RUD1000 Manuel d'utilisation

Page 10

Advertising
background image

10

NOTE: Fill amounts shown are for standard powdered detergent.
Amounts may vary if you use liquid or concentrated powdered
detergent. Follow instructions on the package when using liquid
dishwasher detergent or concentrated powdered detergent.

Rinse Aid Dispenser

Rinse aids prevent water from forming droplets that can dry as
spots or streaks. They also improve drying by allowing water to
drain off of the dishes during the final rinse by releasing a small
amount of the rinse aid into the rinse water. Your dishwasher is
designed to use a liquid rinse aid. Do not use a solid or bar-type.

Checking the dispenser

Check the center of the Fill Indicator cap. Clear means it needs
filling.

Or you can remove the Fill Indicator cap. If an “E” is visible, the
dispenser is empty.

Filling the dispenser

The rinse aid dispenser holds 6 oz (175 mL) of rinse aid. Under
normal conditions, this will last for about three months. You do
not have to wait until the dispenser is empty to refill it. Try to keep
it full, but be careful not to overfill it.

1. Make sure the dishwasher door is completely open.

2. Remove the Fill Indicator cap.

3. Add rinse aid. Fill to the smallest opening in the lower part of

the dispenser. Overfilling can cause the rinse aid to leak out,
and could cause oversudsing.

4. Clean up any spilled rinse aid with a damp cloth.

5. Replace the Fill Indicator cap. Close tightly.

Where to fill

Top of 3rd step (3 tbs or 45 g)

Top of 2nd step (2 tbs or 30 g)

Top of 1st step (1 tb or 15 g)

Water Hardness

Amount of Detergent

Soft to Medium
Hard Water

0 to 6 grains per
gallon

For normally soiled loads

Fill the Main Wash section to the
top of the 2nd step (2 tbs or 30 g)

Fill the Pre-Wash section to the
top of the 2nd step (2 tbs or 30 g)
if needed

NOTE: Add only 1 tb or 15 g of
detergent to both sections if dishes
are pre-rinsed or the water is very
soft (0 to 2 grains per gallon).

For heavily soiled loads

Fill the Main Wash section to the
top of the 3rd step (3 tbs or 45 g)

Fill the Pre-Wash section to the
top of the 2nd step (2 tbs or 30 g)

Medium to Hard
Water

7 to 12 grains per
gallon

For normally soiled and
heavily soiled loads

Fill the Main Wash section to the
top of the 3rd step (3 tbs or 45 g)

Fill the Pre-Wash section to the
top of the 2nd step (2 tbs or 30 g)
if needed

OR

Advertising
Ce manuel est liée aux produits suivants: