Recoton/Advent Acoustic Research Wireless AW811 - Manuel (Page 6)

5
H
I
J
L
K
H. Audio level indicator light I. Transmitter power input jack
J. Input level control
K. Audio input cable
L. Channel select switch
III. Adjusting the Transmitter
1. Turn ON your audio source (i.e., A/V receiver, TV, stereo, etc.) and play
music at a normal listening volume.
2. Set the channel select switch (L) on the back of the transmitter to 1, 2 or 3.
The transmitter provides three different broadcasting frequencies. In the
event that you experience poor reception or interference, try choosing a
different frequency by moving the channel select switch to another position.
3. Turn the input level control (J) down. (To your left when looking at the front
of the transmitter.)
4. Check the audio level indicator light (H) on the front of the transmitter. If
the light flickers intermittently (about half the time), the transmitter is
properly adjusted. If the light does not blink or is flickering very rapidly, turn
the input level control (J) slowly UP until the light flickers intermittently.
Note: If the light does not flicker, please check the following:
- Confirm the transmitter AC power adapter (M) is securely connected.
- Confirm the cable from the transmitter is securely connected to the audio
source output (TV, A/V receiver, etc.).
- Move the input level control (J) all the way UP and check if the transmitter
is connected to a variable audio output such as headphone jack or TV audio
output. Adjust the volume on the audio source up or down as necessary to
make the audio level indicator light (H) flicker intermittently. If you are
unclear as to the kind of output (variable or fixed) you are using, please see
More Helpful Information on page 7.