NuTone CT650 - Manuel (Page 6)

HOW TO USE THE POWER BRUSH
NOTE:
The Power Brush is not recommended for use on bare floors. Wand release
on Power Brush allows you to quickly disconnect wands and switch to
Combination Floor/Rug Tool for use on bare floors.
Always pick up hard or sharp objects by hand before using your Power Brush.
Items such as pins, hairpins, tacks, crayons and pencil stubs may damage the
brush roll or may break a belt.
HANDLE RELEASE
Push down on Power Brush handle release
pedal; pull wand/hose assembly back to com-
fortable work position. Return the handle to
the upright position for storage.
HEIGHT ADJUSTMENT
Select height setting by depressing height
adjustment pedal to desired position: Extra-Low, Low, Medium or High.
EDGE CLEANER
Brush extends full width for effective edge cleaning along both sides of nozzle.
To operate, simply run cleaner along edge board. Rubber bumper protects
furniture and baseboards.
MAINTAINING POWER BRUSH
NOTE: Disconnect power cord and wands from electrical hose before clean-
ing Power Brush.
The instructions given in this booklet serve as a guide to routine maintenance.
To avoid unnecessary service calls, check the belt and brush roll often. Replace
the belt if it is stretched or cracked. Clean the brush roll bristles when they are
wrapped with thread and hair. Build-up could cause the brush to rotate unevenly.
GENERAL CARE
To keep the Power Brush housing clean, it can be wiped with a damp cloth and
a mild soap solution, then thoroughly dried. Never use any type of chemical as
chemicals can damage the housing. When not in use, the Power Brush should be
stored in a clean, dry place.
The motor is permanently lubricated and sealed. Do not oil the motor at any
time.
Pile Height Pedal
Handle
Release
Pedal
Pile
Height
Indicator
6
5. Alignez le
devant du
couvercle
et le socle.
Déposez
le couver-
cle sur l’a-
vant du
socle,
comme illustré.
7. Rabaissez le couvercle et
appuyez ferme-
ment dessus
jusqu’à ce que
les agrafes
latérales
arrière s’en-
cliquent.
Tournez le
balai motorisé à l’envers et
remettez en place les deux
vis du couvercle.
REMPLACEMENT DE L’AMPOULE
1. Retirez le couvercle comme indiqué
à la section REMPLACEMENT DE
LA COURROIE ET NETTOYAGE
DE LA BROSSE.
2. Poussez sur
l’ampoule et
faites-la
tourner dans
le sens anti-
horaire, puis
tirez dessus
pour l’enlever.
3. Insérez l’am-
poule, poussez
dessus puis
faites-la tourner
dans le sens
horaire.
L’ampoule ne
doit pas être d’une puissance supérieure
à 130 V / 15 W.
4. Replacer le couvercle sur le balai
motorisé, comme illustré à la page 10.
NOTE: Utilisez une ampoule numéro
9123A.
6. NOTE:
Sur les
modèles dotés
d’un capteur de
saleté, assurez-
vous que la carte
est à la verticale
et que les fils sont
bien repliés,
comme illustré.
Couvercle Socle
Pousser et
tourner
11
Pousser et
tourner