Assembly – Poulan 417183 Manuel d'utilisation

Page 7

Advertising
background image

7

ASSEMBLY

FIG. 3

CHECK BATTERY (See Fig. 3)

• Lift seat pan to raised position.
• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in MAINTENANCE section of this

manual for charging instructions).

SEAT PAN

LABEL

NOTE: You may now roll or drive your tractor off the skid.

Follow the ap pro pri ate instruction below to remove the

tractor from the skid.

WARNING: Before start ing, read, un der stand and fol low

all in struc tions in the Op er a tion section of this man u al. Be

sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID (See Op-

er a tion section for location and function of

con trols)

• Press lift lever plunger and raise attachment lift lever

to its highest po si tion.

• Release parking brake by de press ing clutch/brake

ped al.

• Place freewheel control in "trans mis sion dis en gaged

position" (See “TO TRANS PORT” in the Op er a tion

section of this manual).

• Roll tractor forward off skid.

Remove banding holding the deflector shield up against

tractor.

ADJUSTMENT

KNOB

FLAT WASHER

02615

02617

SEAT PAN

SHOULDER

BOLTS

SEAT

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment knob.
• Remove adjustment knob and flat washer securing

seat to cardboard packing and set aside for assembly

of seat to tractor.

Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

• Place seat on seat pan so head of shoulder bolts are

positioned over the large slotted holes in pan.

• Push down on seat to engage shoulder bolts in slots

and pull seat towards rear of tractor.

• Pivot seat and pan forward and as sem ble adjustment

knob and flat washer loosely. Do not tighten.

• Lower seat into operating position and sit in seat.

Slide seat until a comfortable position is reached which

allows you to press clutch/brake pedal all the way

down.

• Get off seat without moving its ad just ed position.
• Raise seat and tighten adjustment knob securely.

FIG. 2

Advertising