Panasonic DVD-LV57 - Manuel (Page 10)

10
RQT6077
Getting Started
Preparing the remote
control
Insert the battery
(Lithium battery)
1
2
3
Face + upwards.
About 7 m
(23 feet) in
front of the
signal sensor
Remote control
signal sensor
Power supply
DC IN 9V
P O R T A B L E D V D / V ID E O C D / C D P L A Y E R
D V D -L V 6 0
Household AC
outlet
(AC 120 V, 60 Hz)
%
DC IN 9 V
This unit (Left side)
The [ Í ] indicator lights.
Front of
this unit
The unit is in the standby condition
(the [
Í ] indicator lights) when the AC
adaptor is connected. The primary cir-
cuit is always “live” as long as the AC
adaptor is connected to an electrical
outlet.
1
2
Using the AC adaptor
∫ When the unit is not going to be
used for a long time
The unit consumes 2 W when in standby
mode.
To conserve power, disconnect the AC
adaptor from the AC outlet.
Note
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on page 6.
Note
≥ Do not expose the remote control signal
sensor to bright light.
≥ Do not place obstacles between the
remote control signal sensor and the
remote control.
≥ Do not use another unit’s remote control
at the same time.
∫ Replacing the button-type battery
The battery normally lasts for about a
year. Replace if the remote control fails to
operate the unit when used within the
operation range.
Note
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on pages 6 and 7.
Operation range