Pioneer DV-PT100 - Manuel (Page 9)

9
Inserting Batteries
1 2 3
Operation
• Aim the remote control at the remote sensor and press control
buttons to operate.
• Operate the remote control within 30° angle on either side of the
remote sensor, up to a distance of Approx. 5 meters (15 ft.).
Remote control / Power source
Close the cover. Insert two AAA/R03 batteries into
the battery compartment following
the indications (+,–) inside the
compartment. Open the battery
compartment cover on the
back of the remote control.
Approx. 5 meters (15 ft.)
Battery precautions
Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:
• Don't mix new and old batteries together.
• Don't use different kinds of battery together-although they may look similar, different batteries may have different voltages.
• Make sure that the plus and minus ends of each battery match the indications in the battery compartment.
• Remove batteries from equipment that isn't going to be used for a month or more.
• Do not try to recharge batteries not intended to be recharged; they can overheat ant rupture. (Follow battery manufacturer’s
directions.)
• When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules
that apply in your country or area.
• Press STANDBY/ON to turn the DVD/VCR on or off.
• Press CH
or CH to move through the channels one channel at a time.
• The CH / and SET +/– are also used to navigate on-screen menu system.
• You can directly access specific channels using Number keys pad.
• Each press of DVD/VCR on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD
screen (DVD mode).
Remote control basics
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC
cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to other than the specified
voltage (120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non-polarized AC
outlet, do not attempt to file or cut the blade. It is the user’s
responsibility to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit and the
unit fails to function, simply unplug the unit from the AC outlet
and plug it back in. The unit should return to normal operation.
Polarized AC Cord Plug
(One blade is wider than the other.)
AC Outlet
Wider Hole
and Blade
Power source
VRB1362A_06-09.pm6 7/10/04, 16:07 9