Chapter 4 making network connections, Connecting network devices, Twisted-pair devices – LevelOne ProCon GSW-2476 Manuel d'utilisation
Page 37: Cabling guidelines, Making network connections -1, Cabling guidelines -1
4-1
C
HAPTER
4
M
AKING
N
ETWORK
C
ONNECTIONS
Connecting Network Devices
GSW-2476 is designed to interconnect multiple segments (or collision
domains). It can be connected to network cards in PCs and servers, as well
as to hubs, switches or routers. It may also be connected to devices using
optional SFP transceivers.
Twisted-Pair Devices
Each device requires an unshielded twisted-pair (UTP) cable with RJ-45
connectors at both ends. Use Category 5, 5e or 6 cable for 1000BASE-T
connections, Category 5 or better for 100BASE-TX connections, and
Category 3 or better for 10BASE-T connections.
Cabling Guidelines
The RJ-45 ports on the switch support automatic MDI/MDI-X pinout
configuration, so you can use standard straight-through twisted-pair cables
to connect to any other network device (PCs, servers, switches, routers, or
hubs).
See Appendix B “Cables” for further information on cabling.
Caution: Do not plug a phone jack connector into an RJ-45
port. This will damage the switch. Use only twisted-pair cables
with RJ-45 connectors that conform to FCC standards.