KITCHENAID KBAU482V - Manuel (Page 9)

9
To Replace the Door:
1. Slide the door hinges into the slots in the frame and push in
to seat hinges.
2. Locate the 4 hinge screw mounting holes through the top and
bottom of the frame and replace the 4 screws. Do not tighten.
3. Check and adjust door then tighten the screws. See “Access
Door Alignment - Style 2 Only.”
4. Repeat steps 1 through 3 for the other door if necessary.
18" (45.7 cm) Access Door Reversal -
Style 2 Only
The 18" (45.7 cm) access door can be reversed from a right-side
opening to a left-side opening. This must be done prior to
mounting the door assembly into the cabinet opening.
To remove the access door from the frame:
1. Lay the access door assembly on a covered surface.
2. Open the door to the full open position.
3. Locate and remove the 4 door hinge mounting screws in the
door frame.
4. Pull the door away from the center to slide the door hinges
out of the hinge slots in the frame.
5. Lay the front face of the access door on a covered surface.
6. With a #3 Phillips screwdriver, remove the 4 hinge screws
from the door.
7. With a #2 Phillips screwdriver, remove the screws from
around the perimeter of the inner door.
8. Remove the inner door panel and slide the 2 door hinges out
of the hinge slots in the door.
9. Replace the door hinges by sliding them into the hinge slots
on the opposite side of the door.
10. Rotate the inner door panel 180° and place the inner door
panel so that the hinge slots in the inner door slide over the
hinges.
A. Top door hinge mounting screws
(2 - underside of frame)
B. Bottom door hinge mounting screws (2)
A
B
A. Top hinge screws (2)
B. Bottom hinge screws (2)
C. Hinges (2)
A
B
C