KITCHENAID KBAU482V - Manuel (Page 10)

10
11. With a #3 Phillips screwdriver, replace the 4 hinge screws in
the door. Do not tighten.
12. With a #2 Phillips screwdriver, replace the screws around the
perimeter of the inner door but do not tighten. After all the
screws have been installed, tighten the screws.
13. Tighten the 4 hinge screws.
To replace the door into the frame:
1. Slide the door hinges into the slots in the frame and push in
to seat hinges.
2. Locate the 4 hinge screw mounting holes through the top and
bottom of the frame and replace the 4 screws. Do not tighten.
3. Check and adjust door then tighten the screws. See “Access
Door Alignment - Style 2 Only.”
4. Install 18" (45.7 cm) access door assembly into cabinet
cutout. See “Install Access Door - Style 2.”
Attach Condiment Shelf - Styles 1 and 2
1. Open access door.
2. Use a short #2 Phillips screwdriver or a 90° screwdriver with a
#2 Phillips screw bit to loosen the 2 mounting screws on the
inner door panel.
3. Position the condiment shelf so that the large ends of the
keyhole slots are over the 2 mounting screws.
4. Lower the condiment shelf until the 2 mounting screws are in
the narrow ends of the keyhole slots.
5. Tighten the screws.
A. Top hinge screws (2)
B. Bottom hinge screws (2)
C. Hinges (2)
A
B
C
A. Mounting screws
A. Mounting screw in keyhole slot
B. Condiment shelf
A
B
A