KITCHENAID KBZU122VSS - Manuel (Page 19)

19
9. Use pipe wrench to install the convertible regulator. Brass
cap will be facing up when tight.
10. To make sure the regulator is set for Natural gas, use
adjustable wrench to remove brass cap on appliance
regulator.
11. Examine the stem on the brass cap. If the letters “NAT” are
not showing on the end of the plastic stem farthest away from
the brass cap, remove stem from cap, turn it over and snap
stem back into the cap so the letters “NAT” are at the end of
the stem farthest away from the brass cap.
12. Reinstall cap onto convertible regulator.
Change the Side burner orifices
1. Remove the side burner grates.
2. Remove the burner caps. The caps are interlocked to the
burner base. Twist and lift the burner caps to remove.
3. Use 10 mm socket and wrench or 10 mm nut driver to
remove the brass orifices from inside the burner base.
4. Use 10 mm socket and wrench or 10 mm nut driver to install
the new 2.1 mm orifices supplied with this kit.
NOTE: The number 2.1 is stamped on the orifice for
identification.
5. Repeat the procedure for the other burner.
6. Replace the burner top and caps. Align the notches in the
bottom of the burner top with the tabs on the burner base
and twist until the burner top is seated on the burner base.
You will feel it drop into the deep notch.
7. Replace the side burner grates.
Hook up to Natural gas and Leak Test
1. Use pipe wrench to connect certified ¹⁄₂" (1.3 cm) gas supply
pipe to inlet side of regulator from Natural gas supply
according to local codes requirements. Use pipe thread
sealant that is certified for use with LP gas at connections
where required. There must be a certified manual shutoff
valve in the gas supply line near the grill for easy access.
2. Turn on the gas supply to the grill.
3. Test all connections using an approved noncorrosive leak-
detection solution. Bubbles will show a leak. Correct any leak
found.
Record Conversion
1. The appliance nameplate is located inside the grill cabinet on
the right-hand cabinet side. With a permanent marker, check
the box next to “Natural gas” and mark through “LP -
Propane.”
In the last page of the Use and Care Guide, write “Converted to
Natural Gas.” Also record the conversion date and the
technician/company that performed the conversion.
NOTE: Place LP gas parts in plastic parts bag for future use and
keep with pack containing literature.
Check and Adjust the Burners
The burners are tested and factory-set for most efficient
operation. However, variations in gas supply and other conditions
may make minor adjustments to low flame setting necessary.
It is recommended that a qualified person make burner
adjustments.
A. Brass elbow
B. Convertible regulator
A B
NA
T
A. Burner top notches
B. Burner base tabs
B A
³⁄₄ " - 1"
(1.9 - 2.5 cm)
on all burner ports
with burners on
"HI" setting