KITCHENAID KFFU271TSS - Manuel (Page 4)

4
INSTALLATION INSTRUCTIONS
Built-In Refreshment Center
Use a certified plumber to connect and install potable water
supply and drain system to outdoor refreshment center
according to local code requirements.
1. Using two or more people, set the refreshment center on a
covered surface.
2. Check that you have the drain connections, in accordance
with local codes, under the refreshment center.
3. Remove the faucet from the ice bin.
4. Install the faucet and fasten securely.
5. Install water inlet connection in a convenient location under
the cutout. Position the water inlet connection so that the
plastic hose easily reaches the filter inlet connection.
6. Ice bin drain and sink drain fittings to be connected to drain
system in accordance with local code requirements.
7. Apply a bead of all weather clear silicone on the under side of
the two sides of mounting trim.
8. Using two or more people, place the refreshment center into
the cutout. Immediately remove any excess silicone.
9. Connect the plastic hose from the water filter to the faucet
connection and securely tighten.
A. Faucet
B. Brass escutcheon with “O” ring
C. Sink
D. Plastic washer
E. Locking nut
A. Tubing from water filter (inlet)
B. Hose connector
C. Hose connector nut
D. Brass locking nut
E. Inlet connector
F. Exterior side of mounting panel
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refreshment center.
Failure to do so can result in back or other injury.
A
B
C
D
E
A
B
C
E
D
F
A. Underside of mounting trim
A. Plastic tube insert
B. Plastic ferrule
C. Compression nut
D. Plastic hose
E. Filter
A
D
E
A
B
C