Samsung SR8830 - Manuel (Page 22)

22_ Operating the cleaner
Operating the cleaner
INSTALLING THE ROBOTIC VACUUM CLEANER
CHARGING
2. Check the charge status of the robotic vacuum
cleaner.
- When charging starts, the battery level indicator and
“ ” will be displayed in sequence in the display panel.
- When charging is complete, the battery level indicator and
“FULL” will be displayed in the display panel.
1. After aligning the charge pins of the main unit with
the charge pin of the charger station, press the main
unit until you hear a “Recharging power” sound from
the charger.
- The Charging Lamp turns green.
When the product is initially purchased, the battery
is fully discharged, and you must charge the robotic
vacuum cleaner manually.
Power Lamp
Charging Lamp
Power
Lamp
Charging Lamp
NOTE
● When the product is initially purchased, it will take about 120 minutes to fully charge the battery
and will run for about 90 minutes.
● When charging the battery while the battery is over-heated, the charging time can increase.
● Measures to take when charging is not smooth.
When the robotic vacuum cleaner cannot be automatically charged, check the following:
- Turn the Power Switch at the bottom of the robotic vacuum cleaner off and on (Reset).
- Re-plug the power of the charger (Reset).
- Check whether there are any foreign substances on the charge connector and wipe the
charge connector on the main unit and the charger with a dry cloth.
- Check whether there are objects near the charger that are strong reflectors.
● When separating the robotic vacuum cleaner from the charger, it will discharge naturally.
- Charge the robotic vacuum cleaner through the charger, if possible. (When leaving your home
unattended for a long period of time due to a business trip, travelling etc., turn off the Power
Switch of the robotic vacuum cleaner and unplug the power of the charger to store them.)
Turn on the Power Switch at the bottom of the product.
■ When the battery level display flashes
while cleaning, the robotic vacuum
cleaner stops vacuuming and
automatically charges itself at the charger.
■ When the battery level flashes and “LO” is displayed while cleaning,
robotic vacuum cleaner cannot be operated by the remote controller
or the buttons on the main unit. In this case, directly carry the robotic
vacuum cleaner to the charger to charge the battery. (This is when
the battery is completely discharged.)
Charge
complete
Charging Required
charging
<Charge display>
OFF ON
Charging Fully charged
DJ68-00518A (EN-1)-0.1.indd 22 2009.11.5 11:34:0 AM