Sharp FP-R30CX - Manuel (Page 16)

E-14
Transmitter
Pollen Mode Operation
Button
See Page E-12
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
• The indicator light shows the
remaining time.
• The unit will stop operation
when the timer is up.
1 hour
Cancel
4 hours
8 hours
Plasmacluster Ion Mode Selections
AUTO
When pressed, the unit will switch between Clean
Mode and the Ion Control Mode automatically
depending on the amount of impurities in the air
as detected by the odor sensor. Clean Mode will
operate for 1 minute when the Auto function is
selected.
When pressed, the unit will constantly operate
in Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
When pressed, the unit will constantly
operate in the Clean Mode, in which
the same numbers of positive and
negative ions are discharged. The
Plasmacluster Indicator Light is blue.
OFF
The generation of ions will cease and
the Plasmacluster Indicator Light will
go out.
REMOTE CONTROL OPERATION
OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• QUICK CLEAN
• LIGHTS ON/OFF
Plasmacluster Ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
CLEAN
ION CONTROL
POWER ON/OFF Button
• When you press the
POWER ON/OFF Button,
a short beep will sound
and operation will start in
AUTO Mode.
• Unless the power has been
interrupted, the operation
starts in the previous mode
the unit was operated in.
• To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
The fan speed can be
switched among Silent,
Medium and MAX settings.
QUICK CLEAN Button
See page E-12
LIGHTS ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.