Troubleshooting, Error display – Sharp FP-R30CX Manuel d'utilisation

Page 19

Advertising
background image

ENGLISH

FRANÇAIS

E-17

TROUBLESHOOTING

Before calling for repair, please review the list below, since the problem may not be a unit malfunction.

SYMPTOM

REMEDY (not a malfunction)

The Remote Control does not

work

• Have the batteries been depleted?
• Are the batteries inserted correctly?
• Is a fluorescent lighting in the room flickering due to service

life?

Odors and smoke are not re-

moved

• Clean or Replace the filters if they appear to be heavily soiled.

(Refer to E-15)

The CLEAN-SIGN Light lights

green even when the air is im-

pure

• The air could be impure at the time the unit was plugged in.

(Refer to E-13)

The CLEAN-SIGN Light lights

orange or red even when the air

is clean

• The sensitivity of the sensor becomes unstable when the

opening of the odor sensor is dirty or is clogged.
Clean the dust around the sensor opening using a vacuum
cleaner. (Refer to E-15)

• When in Clean Mode ( or Ion Control Mode), the Plasmacluster

Indicator Light color will not change.

A clicking or ticking sound is

heard from the unit

• Clicking sound is emitted when the unit is in the Ion Control

Mode, and ticking sound is emitted when the unit is generating
ions.
If the sound is irritating, set the unit away from you.

The discharged air has an

aroma or odor.

• Check to see if the filters are heavily soiled.

Replace the filters.(Refer to E-16)

• Plasmacluster Air Purifiers emit small traces of ozone which

may produce an odor. These ozone emissions are well below
safety levels set by the FDA.

The Plasmacluster Indicator

Light remains green (or blue)

and does not change

The unit does not operate when

cigarette smoke is in the air.

• Is the unit installed in a location that is difficult for the sensor to

detect cigarette smoke?

• Are the odor sensor openings blocked or clogged?

(In this case, clean the openings.) (Refer to E-15)

The Plasmacluster Indicator

Light or the CLEAN-SIGN Light

will not activate.

• Check to see if the Lights OFF Mode on the Remote Control is

selected. If so, then press the Lights ON/OFF Button on the
Remote Control to activate the Lights light.
(Refer to E-14)

ERROR DISPLAY

LAMP INDICATION

REMEDY

The “Silent” Fan Speed Indica-

tor Light blinks.

Fan motor disconnected or abnormal.
Operation stops.
• Pressing the Power ON/OFF button will reset the error display,

but if error occurs again, contact the shop where you purchased
the unit.

Advertising