Shindaiwa PowerBroom 80732 - Manuel (Page 8)

8
ENGLISH
PB2500.10
PB10
Assembly: Handle
Handle
Hex Nut
Outer Tube
Adjustment
Knob
Mounting
Screw
Throttle
Assembly
Washer
Connect the Handle to the Outer Tube
Figure 13
PB2500.09
3/16-1/4 inch (4-6 mm)
Throttle Freeplay
Assembly: Adjust Throttle Lever Free Play
1. Loosen the air cleaner cover knob
and remove the air cleaner cover.
See Figure 11.
2. Loosen the lock nut on the cable
adjuster. See Figure 12.
PB2500.05
Cable
Adjuster
Figure 11
Figure 12
The throttle lever free play should be
approxiamtely 3/16-1/4 inch(4-6 mm).
See Figure 10. Make sure that the throttle
lever operates smoothly without binding.
If it becomes necessary to adjust the lever
freeplay, follow the procedures and
illustrations that follow.
Figure 10
3. Turn the cable adjuster in or out as
required to obtain proper free play
3/16-1/4 inch(4-6 mm).
See Figure 12.
4. Tighten the locknut.
Lock
Nut
5. Reinstall the air cleaner cover.
1. Remove both screws from the handle.
2. While spreading the handle at the
mounting hole, position the handle on
the outer tube as shown.
3. Reinstall the two mounting screws in
the handle, but do not tighten them at
this time.
IMPORTANT!
One side of the handle is recessed to
receive the hex nuts.
4. Locate the handle at the best position
for operator comfort (usually about 10
inches ahead of the throttle lever), and
secure it by tightening the knob at the
handle base.