Sun Microsystems SUN BLADE X6250 - Manuel (Page 44)

36 Sun Blade X6250 Server Module Windows Operating System Installation Guide • September 2008
13. Press either Enter to select Express Setup, or C to select Custom Setup .
If you created a RAID volume on your boot disk as part of your prerequisite
preparations for installing Windows, press C to select Custom Setup and
manually partition the disk. Make sure to reserve a minimum of 200 MB of
unpartitioned space at the end of the drive. Otherwise, press Enter to select
Express Setup
.
14. Follow the on-screen instructions to complete the initial setup of Windows
Server 2003 until you are prompted with the following message:
Remove disks or other media. Press any key to restart.
When this message appears you will need to complete one of the following steps,
depending on which driver delivery method you have chosen, to complete the
installation:
■ Floppy Disk Local: Remove the floppy disk from the floppy drive attached to
the server.
■ Floppy Disk Remote: Remove the floppy disk from the JavaRConsole server.
■
Floppy Image (only supported for server modules using ILOM): Deselect
Floppy Image from the JavaRConsole Devices menu.
Then, press any key to restart the system and complete the Windows Server 2003
Installation.
15. Proceed to Chapter 8 “Updating the Critical Server-Specific Drivers.”