Sony AVD-S50 - Manuel (Page 22)

22 GB
Step 3: TV Hookups
Connect a SCART (EURO AV) cord (supplied) and mains lead in the order (1 – 3) shown
below. Be sure to connect the SCART (EURO AV) cord to the T EURO AV OUTPUT (TO
TV) jack on the receiver. Also, be sure to connect the mains lead last.
Notes
• Plug cords securely to prevent unwanted noise.
• Refer to the instructions supplied with the TV.
• The receiver cannot output the component video signal.
• The receiver cannot output the audio signal of the connected TV. When you listen to the audio signal of the TV
by using the connected speakers, input the audio signal of the TV from the t EURO AV INPUT (FROM
VIDEO) jack.
When you connect using the SCART (EURO AV) cord, check that the TV conforms to S video
or RGB signals. If the TV conforms to S video, change the input mode of the TV to RGB
signals. Refer to the operating instructions supplied with the TV to be connected. Also, when
you set “LINE” to “VIDEO” or “RGB” (same as TV) under “SCREEN SETUP” in the Setup
Display (page 68), use a SCART (EURO AV) cord that conforms to each signal.
When connecting to a standard 4:3 screen TV
Depending on the disc, the image may not fit your TV screen.
If you want to change the aspect ratio, please refer to page 67.
COAXIAL
OUT IN
OUT
ANALOG
FRONT CENTER
AM
L
R
FM
75 Ω
ANTENNA SPEAKERS IMPEDANCE USE 6–16 Ω
SUB
WOOFER
OUT
OPTICAL
1
OPT IN
2
OPT IN
3
COAX IN
ANALOG DIGITAL
L R
SURROUND
L R
+
–
EURO AV OUTPUT(TO TV) EURO AV INPUT(FROM VIDEO)
To T EURO AV OUTPUT (TO TV) jack
To SCART (EURO AV) input
Super Audio CD/DVD receiver
TV
1 SCART (EURO AV) cord
(supplied)
3 a mains lead
2 a mains lead