Sony PEGA-WL110 - Manuel (Page 35)

35 US
Symptom
You cannot connect
your CLIÉ handheld to
an Wireless LAN access
point.
You forget a WEP
(encryption) key.
You cannot access the
Internet.
You cannot send or
receive e-mail.
Cause/Remedy
An obstacle may be blocking off radio
waves (e.g., metal plate, concrete block,
water) between your CLIÉ handheld and
the Wireless LAN access point.
p Move your CLIÉ handheld and/or the
Wireless LAN access point to a different
place.
p Disable the power saving mode. For details,
see “Advanced Settings” on page 20.
The channel of the Wireless LAN access
point is not set from 1ch. to 11ch..
p Change the channel setting of the
Wireless LAN access point.
There is a device operating at the 2.4 GHz
frequency band (microwave oven,
Bluetooth-enabled device, etc.) around the
CLIÉ handheld.
p Turn the device off or keep the device
and the CLIÉ handheld apart.
p Set WEP (encryption) key of the Wireless
LAN access point again. For details, see
the operating instructions of the Wireless
LAN access point.
The Wireless LAN access point you are
using is not connected to the Internet.
p The settings of the Wireless LAN access point
to the Internet is wrong. Correct the settings
of the Wireless LAN access point to the
Internet, following the operating instructions
of the Wireless LAN access point.
If some network security, such as Firewall,
is in place, there is some possibility that
access to the Internet will be refused.
p Ask your System Administrator about the
settings for your network security.
p Check the settings of the e-mailing
software you are using. For details on
how to set the e-mailing software, see its
operating instructions.
Continued on next page