Sony TA-P9000ES - Manuel (Page 4)

4 GB
Hooking Up
the
Components
This chapter describes how to connect
a Sony TA-E9000ES control amplifier,
a Sony TA-N9000ES power amplifier,
and your other audio components to
the pre amplifier. Be sure to read this
section before making any
connections.
Unpacking
Check that you received the following items with the unit:
• Audio cord (3)
• Remote commander RM-P9000 (remote) (1)
• R6 (size-AA) batteries (2)
• Control A1 connecting cord (1)
Inserting batteries into the remote
Insert two size-AA (R6) batteries with the + and –
properly oriented in the battery compartment. When
using the remote, point it at the remote sensor g on the
pre amplifier.
z
When to replace batteries
Under normal conditions, the batteries should last for about 6
months. When the remote no longer operates the pre amplifier,
replace all batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use new batteries with old ones.
• Do not mix battery types.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the AC power cords until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio cord, be sure to match the
color-coded pins to the appropriate jacks on the
components: white (left) to white; and red (right) to
red.
• When connecting the woofer or center channel, you can
use either the red or white pins on the audio cord.
}
]
}
]