Iiyama PROLITE E2202WS - Manuel (Page 9)

ENGLISH
CAUTION * 1 The rating of the Power Cable enclosed in 120V area is 10A/125V. If you are using
a power supply higher than this rating, then a power cable with a rating of 10A/
250V must be used.
However, all guarantees and warranties are void for any problems or damage
caused by a power cable not supplied by iiyama.
„ Power Cable* 1 „ D-Sub Signal Cable
„ DVI-D Signal Cable* 2 „ Audio Cable* 3
„ Stand „ Cable Holder
„ User Manual
The following accessories are included in your package. Check to see if they are enclosed with the
monitor. If anything is missing or damaged, please contact your local iiyama dealer or regional iiyama
office.
CHECKING THE CONTENTS OF THE PACKAGE
* 2
Accessory for ProLite E2201W / ProLite E2202WS
* 3
Accessory for ProLite E2202WS / ProLite E2202WSV
FITTING AND REMOVAL OF BASE : ProLite E2201W
Install the stand on a stable surface. The monitor may cause injury or damage if it
falls or is dropped. „ CAUTION
Do not give a strong impact to the monitor. It may cause damage. „
Unplug the monitor before installation to avoid electric shock or damage. „
<Install>
Hold the monitor and push the post down
into the stand.
<Remove>
Press the stopper at the back of the stand
and remove the stand from the post.
Stand
BEFORE YOU OPERATE THE MONITOR 5
Press the stopper