Iiyama PROLITE E2202WS - Manuel (Page 14)

ENGLISH
10 BEFORE YOU OPERATE THE MONITOR
Audio Cable (Accessory)
Computer
D-Sub Signal Cable
(Accessory)
DVI-D Signal Cable*
Power Cable
(Accessory)
CONNECTING YOUR MONITOR : ProLite E2202WS / E2202WSV
[Example of Connection]
A Ensure that both the computer and the monitor are switched off.
B Connect the computer to the monitor with the signal cable. (See page 32 for CONNECTOR PIN
ASSIGNMENT.)
C Connect the monitor to the audio equipment with the Audio Cable when using the audio features.
D Connect the Power Cable to the monitor first and then to the power supply.
NOTE „ The signal cables used for connecting the computer and monitor may vary with the type of
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama office.
„ For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
„ Make sure you tighten the finger screws at each end of the signal cable.
<Back>
* Available for ProLite E2202WS only.
[ Fitting of Cable Holder ]
A Collect cables at the back of the stand.
B Position the Cable Holder at the base of the
stand column by inserting the ‘tabs’ into the
guide holes. Apply gentle pressure downwards
to secure.
[ Removal of Cable Holder ]
A Remove Cable Holder by sliding up the base
column.
Гбвме Ипмдет
Stand