Maytag 6 915555 B - Manuel (Page 9)

8
Care and Cleaning
Clean the cabinet and laminate top with a soft damp
cloth and liquid spray cleaner.
To polish and protect the laminate top, use a product
specifically developed for countertops such as Hope’s
Countertop Polish*.
Apply an appliance wax to the cabinet once a year.
Connecting a Convertible
Turn on the faucet at the sink until the water runs
hot. Turn off the faucet.
Pull the connector from the recess in the back of the
dishwasher.
Press down on the thumb release and lift the con-
nector onto the faucet.
Remove pressure from the thumb release and tug
slightly on the connector to be sure it is securely in place.
Turn the hot water on full force.
Check that the sink drain is open so water from the
dishwasher can drain properly.
Pull the electrical cord from the recess. Plug it into
a properly grounded outlet.
Select the proper cycle and options for the load and
start the dishwasher.
1
2
3
4
5
6
7
8
Pressure
Release
Button
Faucet
Connector
Thumb Release
Disconnecting a Convertible
Be sure to turn the water supply off and press the pres-
sure release button BEFORE removing the con-
nector.
Press down on the thumb release and remove the
connector from the faucet.
Push the connector and hoses back into the cabinet
recess.
Unplug the electrical cord and push it back into the
cabinet recess.
1
2
3
4
Convertible Dishwashers
To Change the Door Panel Insert
(select models)
WARNING: Disconnect electrical power to the
dishwasher before changing the door panel insert.
1. Using a Phillips screw driver, remove either the right or
left-hand door trim strips by removing the three screws.
2. Grasp the panel insert(s) and gently flex out slightly. Slide
Panel(s) out about two inches. Continue to flex insert
panel(s) enough to remove them. Use care, edges may be
sharp.
3. Select color and reinstall panel(s). Place insert panel(s)
(notched corners at the top) on the inside of the lower
door panel trim. Make sure the upper notched corners
of the insert(s) are under the control panel.
4. Reinstall the side trim.
Note: To protect the laminate top from damage, do
not use it as a cutting surface or resting place for
warm/hot cookware. Do not slide ceramic or other
hard or abrasive objects across the surface.
*Brand names are the trademarks of the respective manufacturer.