Monster Power Monster Power PRO 3600 - Manuel (Page 10)

2
THE MONSTER POWER EXCLUSIVE T2 ™ TECHNOLOGY
The Monster Power PRO 3600 PowerCenter features our exclusive Monster T2 technology. T2 is an active electronic
microprocessor-controlled circuit that sits in front of the surge protection circuitry in select Monster Power products.
T2 monitors the line, neutral and ground lines and automatically disconnects the PowerCenter from the AC power
line when a long duration low-voltage sag or high-voltage swell occurs (
continuous voltage below 80Vrms or above
132Vrms). When the voltage sags or swells to these potentially damaging levels, ultra-fast T2 auto-disconnect protection
circuitry shuts down the PowerCenter for 15 seconds. When the under-voltage or over-voltage condition returns to normal,
T2 reconnects the PowerCenter to full operation after 15 seconds. If the fault condition does
not clear, the T2 comparator
circuit keeps the unit shut down.
Unlike ordinary power management devices, T2 will shut down your PRO 3600 PowerCenter before the MOVs
(Metal Oxide Varistors) and thermal fuses sense an overload condition and sacrifice themselves to protect your connected
components. This will extend the PRO 3600 PowerCenter’s life, while providing the system protection you need.