GE Profile 165D4700P388 - Manuel (Page 15)

C
o
n
su
m
e
r
S
u
p
p
o
rt
T
ro
u
b
le
sh
o
o
tin
g
T
ip
s
O
p
e
ra
tin
g
In
st
ru
c
tio
n
s
S
a
fe
ty
In
st
ru
c
tio
n
s
Prior to the first use, the dishwasher needs to
be calibrated for water hardness. Please follow
directions below to calibrate the dishwasher to
the hardness of your tap water.
Determine the Hardness of Your Tap Water
In the bag containing these instructions, you should
find a water hardness test strip package. Read the
instructions on the package, remove the test strip and
follow the instructions to determine the hardness level
of your tap water. You will use this information to
calibrate your dishwasher to dispense the optimal
amount of detergent.
Water hardness test strip indication
Set Control to Calibration Mode
From the standby mode (dishwasher not running
a cycle and the panel lights on), enter the water
hardness selection mode.
Control Calibration
1. Close and latch the door (lights on, dishwasher
not running).
2. Press the SANI WASH and DELAY HOURS pads at
the same time for 3 seconds. The display will show
a number 1 to 5. This is the water hardness value
currently set.
3. Press the SANI WASH pad to raise the value or
the NORMAL WASH pad to lower the value. Set
the water hardness value (1 to 5) to the number
determined with the test strip and table at left.
4. Once the water hardness is set, press the
START/RESET pad to save the setting and return
the dishwasher to normal operation.
You should recalibrate the dispenser if water
conditions change, for example, if a water softener
system is added or removed.
Calibration of Models Without 3-Digit
Display Front Controls
1. Close and latch the door (lights on, dishwasher not
running).
2. Press the SANI WASH and DELAY HOURS pads
together for 3 seconds.
3. To change the setting, press the DELAY HOURS pad
the number of times that corresponds to the water
hardness value. You will hear a confirmation with
beeps for the number of times you pressed the pad.
4. If the number of beeps is not what you desire, start
pressing the DELAY HOURS pad again to reenter
a new water hardness level.
5. Once the water hardness is set, press the
START/RESET pad to save the setting and return
the dishwasher to normal operation.
GEAppliances.com
SmartDispense TM Detergent Dispenser
Water Hardness Calibration
Control Panel
0 RED
1 RED
2 RED
3 RED
4 RED
1
2
3
4
5
SOFT
HARD
Value to Enter
into Dishwasher
15
Press at the same time for 3 seconds. Display
Control Panel
Press NORMAL
WASH pad to lower
the value.
Press SANI
WASH pad to
raise the value.