GE 106636 - Manuel (Page 7)

7
1. Fill the water tank with water
(8 ounces).
2. Plug in iron and turn Temperature/
Steam Dial to highest setting.
Let iron preheat four minutes.
3. Leave Temperature/Steam Dial at
highest setting
and unplug
iron. Hold iron
in ironing posi-
tion over a sink.
Repeatedly push
the Blast of
Steam Button
to aid in the cleaning process.
4. Be careful. Steam and hot water
will pour out of the steam vents.
This cleans the vents. Allow all water
to empty from the water tank. This
will take about two minutes.
5. Do not use salt, vinegar, or commercial
iron cleaners to clean the inside of
the iron.
6. Turn Temperature/Steam Dial to
0 (OFF) . This
cleans the steam
valve inside the
iron.
Self-Clean System
Protective Soleplate Shield
(not available on all models)
There is no need to wait for the iron to
cool before storing. Make sure the iron
has been turned off and unplugged.
Empty all water from iron. Place the
soleplate cover on the iron immediately
after ironing.
CAUTION: The soleplate may be hot, so
care must be used in placing the cover
on the soleplate.
Retractable Cord
(not available on all models)
1. Press and hold the Cord Release
Button while pulling cord to desired
length. Do not unwind cord beyond
indicator on cord.
Cord Release
Button
840084900 Ev01 5/24/01 1:44 PM Page 7