GE 106636 - Manuel (Page 4)

4
To Steam Iron
To Dry Iron
1. Plug iron into electrical outlet. The
Auto Shutoff Reset Button/Light will
come on. If the plug will not fit,
read about the polarized plug in
“Consumer Safety Information.”
2. Turn the Temperature/Steam Dial to
a setting in the
Dry Iron range,
settings 1-3. As
an example, the
illustration
shows the iron
set at 2 (Nylon).
NOTE: To dry iron at setting 4 and
higher, empty all water from the
iron.
3. Preheat for about four minutes
before beginning to iron.
Using Your Iron
1. Fill water tank following instructions
in “Filling the Water Tank.”
2. Plug iron into electrical outlet. The
Auto Shutoff Reset Button/Light will
come on. If the plug will not fit, read
about the polarized plug in
“Consumer Safety Information.”
3. Turn the Temperature/Steam Dial
to a setting in
the Steam Iron
range, settings
4-9. As an
example, the
illustration
shows the iron
set at 7 (Rayon).
4. Preheat for about four minutes
before beginning to iron.
5. The iron will automatically shut off
one hour after the iron is plugged in
and the Auto Shutoff Reset Button/
Light will go out. To turn the iron
back on, press the Auto Shutoff Reset
Button/Light located on the top of
the handle.
6. When finished ironing, turn the
Temperature/
Steam Dial to
0 (OFF)
and
unplug iron.
Allow to cool
and empty water
from water tank.
See “Storing
Your Iron.”
4. The iron will automatically shut off
one hour after the iron is plugged
in and the Auto Shutoff Reset
Button/Light will go out. To turn
the iron back on, press the Auto
Shutoff Reset Button/Light located
on the top of the handle.
5. When finished ironing, turn the
Temperature/
Steam Dial to
0 (OFF)
and
unplug iron.
840084900 Ev01 5/24/01 1:44 PM Page 4