Faber Velvet 630006509 - Manuel (Page 6)

Version 07/11 - Page 6
INSTALL THE RANGEHOOD
1. Remove the rangehood from the carton and place on a
flat surface. Cover the surface to prevent accidental damage.
Remove all parts including the backdraft damper and literature
package before discarding the carton. Remove the grease
filters and set aside.
2. Place the round damper into the exhaust opening of the
rangehood and press down.
FIGURE 5
3. Open the comfort panel as shown in FIGURE 8 by turning
the 2 knobs on the left and right sides of the panel. Remove
the comfort panel by sliding the lever out of the pin on one
side and sliding the comfort panel on the other end out of the
pin. Remove the grease filters by pushing the tabs backwards.
Slide the glass visor forward.
PREPARE THE CABINET
1. Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear wall.
Put a thick, protective covering over cooktops, set-in ranges or
countertops to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center line
of the cabinet on the wall and on the underside of the cabinet
where the rangehood will be installed.
3. If the cabinet bottom is recessed, wood blocks need to
be installed to insure proper alignment with the cabinet bottom.
Wood blocks should be flush or recessed 1/16" to 1/8" within
the cabinet bottom as indicated in FIGURE 4.
FIGURE 4
MAKE THE CUT-OUT OPENING (FIGURE 5)
WHERE THE RANGEHOOD WILL BE INSTALLED.
4. Determine the proper cutouts for the ductwork. Make all
necessary cuts in the walls or cabinets for the ductwork. Install
the ductwork before mounting the rangehood.
5. Determine and make the proper cutout for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Run the Power
Supply Cable through the wall or cabinet. DO NOT turn on the
power until installation is complete. Use caulking to seal around
the wire opening.
FIGURE 6
4. The rangehood mounts to the cabinet by two spring
loaded brackets, one on each side of the rangehood (FIGURE
6) Lift the rangehood into the cutout opening in the cabinet.
Be careful not to damage the cabinet, rangehood or other
appliances.
5. The spring loaded brackets are factory set to ac-
comodate a thickness between 1 3/16" and 2 1/4". If
your cabinet bottom is less than 1 3/16" thick, the spring
loaded brackets can be removed and repositioned down
from the top setting to the bottom setting by removing the
four phillips screws.
6. Tighten the rangehood to the cabinet by rotating the
screws with a phillips screw driver. As seen in (FIGURE
6)
7. The rangehood can be adjusted front to back in order
to have the front of the rangehood even with the front of
the cabinets. Loosen the 4 screws (Vr in FIGURE 7) and
close the glass visor. Adjust the rangehood body until the
front is aligned with the front edge of the cabinet. Once
properly adjusted, slide out the glass visor and tighten the
four screws. INSTALLATION CONTINUED ON PAGE 7.
FIGURE 7
FIGURE 8
CUT-OUT
9 3/4” 25 1/4” - 31 1/4”