FRIGIDAIRE 4400 Series - Manuel (Page 5)

5
Options Selections
Favorite Cycle
The Favorite Cycle option allows you to program
your preferred cycle and options into one button.
Once programmed, simply press the Favorite
Cycle button followed by the Start/Cancel pad.
To program the Favorite Cycle button:
1) Select your preferred cycle and options
2) Hold the Favorite Cycle button for 3 seconds
The display will flash for 2 seconds indicating the
Favorite Cycle option has been programmed.
To change the Favorite Cycle option, simply repeat
steps one and two above.
Hi-Temp
When Hi-Temp option is selected, the dishwasher
heats water in the main wash to approximately
140° F (60° C).
This increase in water temperature helps
dishwasher detergent remove food grease and
soil from dishes more effectively and aids in
drying. Hi-Temp option can be used with all cycles
except Quick Wash and Rinse Only. Hi-Temp is
automatically provided when Heavy Wash cycle is
selected, but the indicator light is not lit.
Sanitize Option
To sanitize your dishes and glassware, select the
Sanitize option. When selected, the light above
the pad will come on and remain on until end of
cycle. The water temperature in the final rinse will
be raised to 154° F (68° C), assuring bacteria is
destroyed. This option is available in Heavy Wash,
Normal Wash and China Crystal cycles. Only
these sanitization cycles have been designed to
meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120° F (49° C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120° F
(49° C).
To turn off the Sanitize option, press the pad a
second time. The light above the pad will turn off.
Operating Instructions
(continued)
No Heat Dry
No Heat Dry option saves electricity since the
heating element is off during drying portion of
cycle. When selected, the light above the pad
will come on and remain on until end of cycle. To
speed the drying process, open the door slightly
after the cycle is complete. Some water droplets
may remain on door and tub and in areas where
dishes touch silverware basket and rack.
To select heated dry, press the pad a second time.
The light above the pad will turn off. Heated dry
provides faster drying since the heating element is
on during the drying portion of the cycle.
When an option is selected, the light above the
pad will come on and remain on until end of cycle.
To turn off the option, press the pad a second time.
The light above the pad will turn off.
Child Lock Controls
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock
the dishwasher controls by pressing and holding
the No Heat Dry pad for 3 seconds. An indicator
light on the lock graphic pad will illuminate when
the controls are locked and no new selections
can be made until the lock is released. To unlock
the controls, press the No Heat Dry pad until the
indicator light goes out.
Delay Start
The Delay Start option allows you to automatically
delay starting your dishwasher from 1-24 hours
depending on your model.
Press the Delay Start pad until the desired delay
time shows in the Status window. A light will come
on indicating the delay start hours and will remain
on until cycle starts.
To cancel the Delay Start option and begin the
cycle before the delay period is over, press the
Start/Cancel pad.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle.
Press Start/Cancel pad and the dishwasher will
start a 2 minute drain. At the end of the drain,
select the desired cycle. Pressing Start/Cancel
again during drain cancels the draining process.