FRIGIDAIRE 4400 Series - Manuel (Page 3)

3
Operating Instructions
Wash Cycle Selections
Note: Cycle times are approximate and will vary
with options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty food
soils. An automatic sensor will check the incoming
water temperature and, if it is not hot enough, the
timer will be delayed for automatic water heating
in the main wash of all cycles. This happens even
when Hi-Temp option has not been selected. When
Hi-Temp is selected, an even higher temperature
will be guaranteed to handle heavier soil loads.
Getting Started
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
4. Select desired Cycle (See Cycle Chart). The
indicator light above the pad will glow when
selected.
5. Select desired Options (See Options). The
indicator light above the pad will glow when
selected.
6. Close door to latch.
7. Run hot water faucet nearest dishwasher until
water is hot. Turn water off.
8. To start, press Start/Cancel pad.
Note: The dishwasher is programmed to
remember your last cycle so you do not have to
reset each time. To start the dishwasher using
the same cycle and options selected on the
previous wash, just press the Start/Cancel pad.