FUNAI CIWL2606 - Manuel (Page 18)

18
EN
CHANNEL SELECTION
You can select the channel by using either [CH K/L]
or Channel number buttons. How to select the
channel in each way is shown below.
1 Using [CH K/L], or Channel number buttons
and pressing [ENTER].
• Using [CH K/L], change the channel.
• Same operation is available with [CHANNEL
K/L] on the top panel of the main unit.
• When you select a channel, press the channel
number you want to view with Channel number
buttons. The selected channel will be displayed.
- When selecting analog channel 12
- When selecting digital channel 12-1
Be sure to press [–] before entering the
minor-channel number.
• If the channel broadcasts NTSC and ATSC both
and you don't press [–], then you will receive the
NTSC channel only. The moment you press [–],
the lowest memorized digital channel will be dis-
played.
• When you press [CH RETURN], the previously
selected channel will be selected.
About minor-channel broadcasting:
There may be different programs being broad-
cast on minor-channels through a single chan-
nel from ATSC. You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
NOTE:
In the DTV broadcasting, one channel sometimes broadcasts
multiple programs depending on the air time. In this case, the
main channel is called major channel and the minor-channel
is called minor channel.
ENTER 1 1 2 -
ENTER 1 2
ENTER
POWER SLEEP
AUDIO
STILL
SETUP
BACK
SCREEN
MODE
INFO
CH RETURN
MUTE VOL. CH
1 2 3
4 5 6
7 8 9
- 0
INPUT
SELECT
ENTER
CH RETURN
MUTE
1 2 3
4 5 6
7 8 9
- 0
CH
VOLUME ADJUSTMENT
This section describes how to adjust the volume
when viewing TV. The Mute function, which is use-
ful when you have a visitor or a phone call, will be
also described.
1
Using [VOL. X/Y] or [MUTE]
[VOL. X/Y]
• You can adjust the audio volume with [VOL. X/Y].
• The volume bar is displayed at the bottom of
the screen when adjusting the volume.
• Same operation is available with [VOLUME
X/Y] on the top panel of the main unit.
• The volume bar display will automatically dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] on the remote control to mute
the sound.
• To release the Mute status, press [MUTE]
again or press [VOL. X/Y].
• “Mute” is displayed on the screen for a few sec-
onds.
Mute
Volume 20
BACK INFO
CH RETURN
MUTE VOL. CH VOL.
NOTE:
“No Signal” will appear on the screen after the
minor-channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
: change automatically
: change manually by pressing [CH / ]
on your remote control.
CH4-1
18:00
18:30
19:00
19:30
20:00
CH4-2
CH4-1
CH4-1
CH4-3
No signal No signal
CH4-3
ATSC
CH4
NTSC
No signal
CH4-2 CH4-1 No signal
W
ATCHING TV
L4303CD_CIWL2606.qx4 06.12.21 18:32 Page 18