FUNAI CIWL2606 - Manuel (Page 13)

13
EN
INITIAL SETTINGS / CHANNEL SETTINGS
3 For TV channels, using [K /L], select “Air”.
For CATV channels, select “Cable”.
• Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
• When the scanning and memorizing are com-
pleted, the lowest memorized channel in the
broadcasting will be displayed.
NOTES:
• If you connect a cable system directly, contact the
CATV installer.
• If you press [POWER] or [SETUP] during Autoscan, this
setting will be canceled.
• If there is no reception connected or poor signal is detected,
a Hint will appear on screen once scanning stops.
Now the system is scanning for channels, please wait.
Exit SETUP
72%
Analog channels 10ch
Digital channels 6ch
Autoscan Autoscan
Autoscan will rescan all channels.
This may take a while to complete.
Select the destination of "ANT. IN" jack.
Back
Air
Cable
Cable
1hour
Air
Cable Or
ANT. IN
AUTOSCAN
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with [CH K/L] and the TV
memorizes them even if you switch wires.
1 Display the setup screen.
• Press [SETUP].
The following setup screen is displayed.
2 Select “CHANNEL” and press [ENTER] to con-
firm.
• Using [K /L], select “Autoscan”.
• Press [ENTER].
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
NOTE:
• Make sure if the TV is connected to antenna or cable.
ENTER
STILL
SETUP
BACK
SCREEN
MODE
INFO
CH RETURN
MUTE VOL. CH
- 0
ENTER
SETUP
C
HANNEL SETTINGS
L4303CD_CIWL2606.qx4 06.12.21 18:32 Page 13