Fisher & Paykel RF175W - Manuel (Page 14)

EN 12
Installation instructions
9 Wind both front feet up and roll the product out of
position.
a Place the packing material in the location
diagonally opposite the front roller that lifts off
the floor.
b Make sure the packaging material stays in place
when the product is pushed back into position.
c Ideally, the packing material is large enough to rest
against the back wall so as to prevent it moving
when the cabinet is pushed into position.
10 Roll the refrigerator back into position and adjust front
rollers as per step 5 (check alignment and door closing
action are satisfactory).
a Make small adjustments to front rollers where
necessary.
b Firmly screw front feet down on the ground.
c Check that the product is stable (all 4 feet are on
the floor). If not, return to step 7 and repeat
8, 9 and 10.
d Place toe grille on the bottom of the refrigerator
(refer to step 5d).
Wall behind
refrigerator
This foot lifts off the floor when pushing
gently on the top front of the refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Fig.7 Stabilizing your refrigerator