Fisher & Paykel RF175W - Manuel (Page 13)

11 EN
Installation instructions
Fig.5 Uneven door alignment
6. Leveling the refrigerator door (RF195A only)
6 If doors are uneven, do the following:
a Determine which door needs to be raised.
b Turn the front roller adjustment screw ( a, Fig.3 ) on that
side clockwise to raise front corner of door.
c If one adjustment screw has reached the limit of its
adjustment range and the doors are still not level, lower
the opposite door by turning the roller adjustment screw
counterclockwise.
d Check with level to verify ⁄” (10 mm) tilt to the back for
proper door closure.
e Once refrigerator is aligned, screw feet firmly in place and
attach toe grille (refer to step 5d).
7. What to do if the product is unstable (all models)
7 Gently pull the refrigerator forward and screw down the feet
until they make contact with the floor.
8 Push the refrigerator back until the rear rollers contact the
floor.
a Measure the gap under the front foot, which has come
off the floor.
b Obtain some solid packing material (hardwood, plastic,
etc), which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode, stain
and/or damage floor coverings.
This foot lifts off the floor when
top front is gently pushed back
Example only
Un-level floor
Fig.6 Unstable refrigerator