FUNAI ELC320EM9 - Manuel (Page 4)

4
EN
I
NTRODUCTION
Symbols Used in this Manual
The following is the description for the symbols used in this manual.
Description refers to:
DTV
: Digital TV operation
TV
: Analog TV operation
If neither symbol appears under the function heading, operation is applicable to both.
5
•
Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
5
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
2 Insert the stand all the way to the
main unit slowly until it clicks.
Make sure not to put the AC power
cord between the stand and the
unit.
3 Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by “ 1 ”, then lift the lever on the bottom
stand and remove the stand from the unit slowly. Be careful not to drop the stand
when you remove it.
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items. •
•
Supplied Accessories 5
ffro
nt sid
e
fro
nt sid
e
screw holes
1
lever
owner’s manual
(1EMN23999) quick start guide
(1EMN24000) remote control
(NF606UD) batteries
(AA x 2) Phillips pan screw for
attaching the stand x 3
(FPH34100)