Heath Zenith Carriage Light with Motion-activated Sensor 52-4477-8 - Manuel (Page 6)

6 598-1285-00
aDJuStMent OF COveraGe area
The sensor on this light fixture detects “motion”
by the movement of heat across the coverage
area. However, following are examples of objects
that also produce heat and can cause the sensor
to trigger:
• Pools of Water • Air Conditioners
• Dryer Vents • Animals
• Heating Vents • Automobile Traffic
If you suspect that a heat source of this type is
triggering the sensor, reduce the sensitivity.
SPeCiFiCatiOnS
Range ............................................. Up to 30 ft. (9.1 m) [varies with surrounding temperature].
Sensing Angle................................. Up to 150°, 240° adjustable
Electrical Load ............................... Up to 100 Watt Maximum Incandescent
Bulb Type ....................................... Medium Base, Type “A”, 100 Watt Maximum
Sensor Capacity .............................. Up to 500 Watt (4.1 A) Maximum
Power Requirements ....................... 120 VAC, 60 Hz
Operating Modes ........................... TEST, AUTO, and MANUAL MODE
ON-Timer ...................................... 1, 5, 10 minutes
Test Timer ...................................... 5 Seconds
Manual Mode Timer ...................... Dusk-to-Dawn
MANUAL MODE
AUTO
TEST ON-TIME Switch at 1, 5, or 10
minutes
MODe SWitCHinG SuMMary
Flip light switch off for
one second then back
on*
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.