Hobart Welding Products 1025 - Manuel (Page 22)

OM-2210 Page 18
4-3. Sequence Of Operation
Press trigger. Pilot arc starts.
After cutting arc starts, slowly
start moving torch across metal.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
Pause briefly at end of
cut before releasing trigger.
Install &
Connect
Equipment
Check Torch
(See Torch
Owner’s Manual)
Check Gas/Air
Pressure
(See Section 4-1)
Set
Controls
Begin
Cutting
EXAMPLE Of Cutting Operation
ST-161 698-B
Turn On
Power Source
Put On Personal
Safety
Equipment
The pilot arc starts immediately when
trigger is pressed.
Place torch tip on edge of metal.
Do not clean torch by hitting it against a
hard surface. Hitting hard surfaces can
damage torch parts and stop proper opera-
tion. Inspect shield cup, tip, and electrode for
wear before cutting or whenever cutting
speed has been significantly reduced (see
torch Owner’s Manual). Do not operate
torch without a tip or electrode in place.
Postflow continues for approx. 20 to
30 seconds after releasing trigger;
cutting arc can be instantly
restarted during postflow by
pressing trigger.