Hamilton Beach JUICE EXTRACTOR 840095500 - Manuel (Page 4)

4
Important Information
• The juice extractor is manufactured
for NORMAL HOUSEHOLD USE. If
you have large quantities, such as
10 pounds or more, process in small
batches, allowing motor to cool
completely between uses.
• When juicing CARROTS, DO NOT
PACK food chute. Place carrots in
food chute one by one, and use
gentle pressure.
• DO NOT OVERLOAD THE FOOD
CHUTE. For best results, simply drop
food pieces, one at a time, into
chute. Gently and slowly press with
food pusher. This will extract the
maximum amount of juice.
• If the juice extractor SEEMS TO
STRUGGLE or slow down, turn the
unit OFF and unplug. Thoroughly
wash the cutter/strainer and separator
according to instructions. Reassemble
and continue juicing.
How to Assemble
Read and follow instructions in “Before First Use.”
1. Place separator on top of base as
shown on page 3.
2. Place cutter/strainer into separator
and gently push until firmly in place.
Once in place, the cutter/strainer
should spin easily.
3. Place cover on top of separator and
cutter/strainer.
4. Position the top of both safety
latches in place, then push in at
bottom to lock. Lock both sides.
DO NOT OPERATE UNIT UNTIL
SAFETY LATCHES ARE LOCKED.
5. Place pulp bin in place. Slide top in
first, then bottom, and snap into
place.
6. Place a container in position,
under juice spout.
NOTE: Check the pulp bin frequently.
It is important to empty the pulp bin
when full and to clean out the separator.
1. For more information, see “Fruit &
Vegetable Preparation.”
2. Cut food into pieces to fit the food
chute.
3. Plug cord into 120 volt AC outlet.
4. Be sure juice container and pulp bin
are in place.
5. Push switch up to turn on. The unit
will not turn on until safety latches
have been closed.
6. Place food in food chute and press
lightly with food pusher. Never use
fingers or utensils other than the
food pusher as a food pusher. Food
How to Use
should be placed in food chute only
when unit is operating. Food can be
continuously placed in food chute
without having to turn unit off.
7. When pulp bin is full, turn unit off. It
is very important to empty the pulp
bin when full. For best performance,
empty pulp bin and clean cutter/
strainer and separator often.
8. When juicing is completed, or when
pulp bin or juice container need to
be emptied, turn unit off and unplug
from outlet. Immediately wash cut-
ter/strainer according to instructions.
840095500 Ev00 1/3/02 3:43 PM Page 4