Excalibur electronic NASCAR 9511-3 - Manuel (Page 5)

• Avoid rough handling such as bumping or dropping.
• Avoid moisture and extreme temperatures. For
best results, use between the temperatures of 39º F and
100º F (4º C and 38º C).
• Never drive your 1:10 Nascar ® RC on a wet floor, on
sand, or in mud, rain or snow. These can damage it.
• Be sure to remove the batteries from your 1:10 Nascar ®
RC and transmitter when storing the product.
• To protect your 1:10 Nascar ® RC’s wheel mechanism
from lint, thread, hair and dust particle, you can use a
small brush, tweezers or tie a small bit of cloth to the
tip of a toothpick, etc., and wipe it off.
• Always keep your 1:10 Nascar ® RC clean. Use a
dampened cloth to wipe off, and then wipe all the water
off with a dry cloth. Never use chemicals to clean the
product.
• Avoid holding the wheels when rotating. Holding them
will cause the electronic components to short-circuit,
overheat and cause malfunction.
8 9
• Do not operate your 1:10 Nascar ® RC in
thunderstorms.
• Do not touch the wheels when the switch is turned
ON
.
• Do not leave your 1:10 Nascar ® RC or transmitter
near sources of heat or under direct sunlight for
long periods of time.
• Do not operate your 1:10 Nascar ® RC near small
children.
• Do not drive your 1:10 Nascar ® RC in busy
streets. Always choose a safe place to play.
Caution Special Care & Handling
ENGLISH ENGLISH