Excalibur electronic 9459 - Manuel (Page 4)

thread, hair or dust.
• When the transmitter
range decreases, replace the
battery in the controller. If
someone uses a CB nearby,
it might interfere with con-
trol of the car. If this hap-
pens, move the car and
transmitter away from the
CB.
Trouble-
shooting
If your 1:10 Aston Martin
doesn’t move, please check
the following potential
causes:
1. The POWER switch is
turned off. If that is the
case, turn the
POWER
switch
on.
2. Your 1:10 Aston
Martin is too far away from
the controller. If that is the
case, bring your 1:10 Aston
Martin closer to the con-
troller.
3. The metal tab in the
battery cartridge is flattened
and not touching the batter-
ies installed. If that is the
case, lift up the metal tab so
it touches the tip of the bat-
tery.
If you lose control of your
1:10 Aston Martin, please
check the following poten-
tial cause:
Another radio control
vehicle using the same fre-
quency is operating near
your vehicle. If that is the
case, you should race other
vehicles that use different
frequencies or channels.
If your 1:10 Aston Martin
drives slowly, please check
the following potential
cause:
There are weak batteries
in the transmitter. If that is
the case, replace with new
batteries.
Getting
Started
To begin, insert the
antenna wire through the
hollow tube. Avoid pulling
the wire too tight. The wire
is on the top of your 1:10
Aston Martin. Tie a knot on
top to secure.
Turn the switch to the
ON
position for power.
In a clockwise direction,
screw the antenna into the
cavity located at the top of
the transmitter.
Use the control switches
on the transmitter to drive
your 1:10 Aston Martin. It
will allow you to drive it
forward, reverse, left and
right.
Use both control switch-
es to turn. If you want to
turn right while driving for-
ward, switch the right
switch right and switch the
left switch up. If you want
to turn left while driving in
reverse, switch the right
switch left and switch the
left switch back.
Tips
• If your vehicle does not
respond to the transmitter,
move closer to your 1:10
Aston Martin and try a-
gain.
• If your vehicle starts to
lose power, it may experi-
ence loss of performance. If
this happens, simply re-
place with new batteries.
• If your vehicle moves
slowly, try changing the
batteries and check the
wheel mechanisms for lint,
6 7
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
ENGLISH ENGLISH