Maytag MFT2776DEM - Manuel (Page 3)

3
Water Filter
Water Filter Installation/Flushing/Replacement
Installation
1. Take the water filter out of its packaging and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
NOTE: See the water filter certification and performance
data information in the Use & Care Guide.
2. The water filter compartment is located in the right-hand
side of the refrigerator ceiling. Push up on the door to
release the catch, then lower the door.
3. Align the arrow on the water filter label with the cutout notch in
the filter housing and insert the filter into the housing.
4. Turn the filter clockwise 90 degrees ( 1 ⁄
4
turn), until it locks into the housing.
NOTE: If the filter is not correctly locked into the housing, the water dispenser
will not operate. Water will not flow from the dispenser.
5. Lift the filter up into the compartment. Close the filter compartment door
completely.
Flushing
IMPORTANT: After connecting the refrigerator to a water source or
replacing the water filter, flush the water system to force air from
the water line to keep the dispenser from dripping.
1. Use a sturdy container to depress and hold the water
dispenser pad for 5 seconds, then release it for 5 seconds.
Repeat until water begins to flow.
2. Continue depressing and releasing the dispenser pad
(5 seconds on, 5 seconds off) until a total of 3 gal. (12 L) of
water has been dispensed.
Replacement
Press WATER FILTER to display the percentage of use remaining in the water filter
(from 99% to 0%).
ALSO
The water filter status lights will let you know when to change your water filter.
• ORDER (Orange) - Order a replacement water filter.
• REPLACE (Red) - Replace the water filter.
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that may contain filterable cysts.