Install pedestal front panel, Securely tighten locknuts – Maytag MHP1000SQ Manuel d'utilisation
Page 6
Advertising
6
Align the front panel with the pedestal and snap in place.
note: Follow the “Showroom Display Kit Installation
Instructions” if you wish to use the two retainer clips included
in the parts bag. Discard the retainer clips if not used.
12.
Install pedestal front panel
36" (914 mm) tall models,
place wide edge of front
panel on bottom
38" (965 mm) tall
models, place wide
edge of front panel
on top
11.
securely tighten locknuts
When the washer/dryer is level, use a 9/16" open-end wrench
to securely tighten all four locknuts against the pedestal.
ImPoRtant: The locknuts must be tightened to prevent
vibration.
Advertising