DCS RDT-305 - Manuel (Page 5)

INTRODUCTION
3
The DCS RDT series ranges are designed with a large number of features available in a multitude of different
combinations. Patented Dual Flow Burners
TM allow for consistently lower simmer temperatures and have a high
output of 17,500 Btu/hr. Also available on the ranges are an 18,000 Btu/hr griddle and/or grill.
The large capacity electric ovens of the Dual Fuel Range feature self-cleaning and convection. The secondary
electric oven found on the left side of the 48” Dual Fuel Range can Bake or Broil, and also has a Proof feature.
All range models require the installation of one of the two (12” or 30”) offered Backguards. (Except island instal-
lation). See page 8.
IMPORTANT INSTALLATION INFORMATION
The RDT series ranges are tested in accordance with ANSI Z21.1 Standard for Household Cooking Gas Appliances.
These ranges must be installed in conjunction with a suitable overhead vent hood (see ventilation
requirements). Due to the professional high heat capacity of this unit, particular attention should be paid to the
hood and duct work installation to ensure it meets local building codes. To eliminate risk of burns or fire by
reaching over heated surface units, cabinet storage located above the surface units should be avoided.
Check local building codes for the proper method of range installation. Local codes vary. Installation, electrical
connections, and grounding must comply with all applicable codes. In the absence of local codes, the range
should be installed accordance with the National Fuel Gas Code ANSI Z223.1 and National Electrical Code
ANSI/NFPA 70. Be sure that the unit being installed is set up for the kind of gas being used. The ranges are
shipped from the factory set and adjusted for natural gas or LP (propane), depending on the specific model
ordered. Verify that the range is compatible with gas supply at the installation site before proceeding
further. Return range to dealer if unit is not set for site gas supply.