Danby DHCC6020 - Manuel (Page 12)

19
Instructions de fonctionnement
Identification des
pièces
Operating Instructions
10
Humidifier
MODE
The operating mode can be defined when the unit is ‘On’ or
in ‘Standby’. The following steps are provided assuming the
unit is in standby mode.
1) Open the upper rear panel and locate the internal reser-
voir fill cap. Proceed to remove the fill cap (fig E.) from the
reservoir.
2) Slowly fill the internal water reservoir with fresh clean
water until the Water Level Display illuminates all four status
bars to signify the tank is full (as shown in Fig G).
3) Replace the fill cap and close the upper rear panel. If you
have removed the water tank during the fill process ensure
that the handle on the internal reservoir has been returned
to it’s original position - flat against the bucket.
4) Depress the ‘Mode’ button on the control panel until the
Humidifier icon is displayed in the LCD screen (Fig H).
5) Select the desired humidity level from 35% RH ~ 80% RH
by depressing either the increase (
) or decrease ( )but-
tons on the control panel. To select continuous as the mode
of operation in lieu of defining a precise humidity level, press
the increase or decrease button until see the “
- - “ in the
set humidity display portion of the LCD, as shown in Fig. I.
6) Depress the power button to start the unit in Humidifier
mode at your specified settings.
Please note: During the Humidifier mode, the fan speed
cannot be changed.
3
_
MODE
Full
39 RH%
ºF
ºC
__
RH%
Fig E
Fig G
Fig H
Fig I
Fill Cap
1. Panneau Supérieure
2. Panneau De Commande Électronique
3. Poignée
4. Panneau de façade (amovible)
5. Roulettes
6. Réservoir Interne
7. Poignée Du Réservoir Interne
8. Bouchon de remplissage
4
1
2
3
8
5
7 6